|
|
|
|
|
|
| Waste IC tray recycling method |
|
|
| Source£ºBoye International Trade Co., Ltd. Release time£º2017-03-29 |
|
|
In the selection of various plastic recycling methods for recycling of waste plastics before, most of the need for plastic sorting. As the IC tray recycling channels and more messy, and some of the plastic after the cost of it is difficult to distinguish the appearance of simple, and therefore, the best plastic products can be marked on the type of information. China, with reference to the American Plastics Association (SPE) proposed and implemented the type of information to develop a GB / T162881996 plastic packaging finished product recovery symbol, although the above symbols can be used to facilitate the sorting, but because there are many unsigned plastic products in China, To the sorting difficult, for the different types of IC tray apart, in order to sort back, first of all to grasp the common knowledge of different plastic, the following describes the simple plastic identification method: plastic heating to identify the three types of plastic heating characteristics is also Different, after the heating method can be identified. Thermoplastics soften when heated, easy to melt, and melt becomes transparent, often from the melt to pull the wire, the general easy to heat. Thermosetting plastics heated to the material before chemical differentiation, adhere to its original hardness is not softened, the scale is more stable, to the differentiation temperature of carbonization. When the elastomer is heated, until the chemical differentiation temperature does not occur before the activity, to the differentiation temperature of the material differentiation of carbonization. Due to the lateral width of the transport equipment, if the 2-way into the fork with 1100 X 1100mm, if the 4 into the fork is selected 1100 X 1100mm or 1100 X 1200mm which can be. The following are the same as the "
Pad 4-way into the fork of the IC tray high-temperature board than the 2 into the fork with less materials, raw materials, low cost, but the shape of chaos, production costs increased. Inductive thinking, 2-way into the IC tray is better. The following are the same as the "
Therefore, to be able to amend the long-term use, the choice of robust 2-way into the IC tray, no longer re-use of the selection of the lighter 4 into the poor no problem. The following are the same as the "
Active warehouse due to the use of two support, with truss girder support 2-way fork into the IC tray robust and safe. The following are the same as the "
About active support of 2-point support and other active machinery and equipment, from the high intensity of thinking 2 to the fork into the IC tray is better. The following are the same as the "
With respect to the long-used wooden pallets, the simple correction of the 2-way fork into the IC tray is better. The following are the same as the "
Plastic IC tray high appearance to identify the appearance of plastic after investigation, can begin to identify the plastic products are the major categories: thermoplastics, thermosetting plastics or elastomers. General thermoplastics are crystalline and amorphous. Crystalline plastic appearance was semi-clear, opaque or not bright, as long as the film was informed of the situation, hardness from soft to horny. The amorphous form is generally colorless and is fully clear when no additive is added, and the hardness is hardened from the horny rubber (this is often added with additives such as plasticizers). Thermoset IC tray High temperature board is generally rich and not transparent, if not filled with transparent. Elastic body with rubber-like feel, there is a certain elongation.
|
|
|
|
|
|
|
|
|
Home